Allen-Bradley Bulletin 1609 User Manual download pdf (Page 7)

Rockwell Automation Publication 1609-UM009C-EN-P - February 2015 7

Bulletin 1609-D Installation Instructions

Battery Wiring and

Installation

Note: Batteries are not included with the 1609-D UPS

1. To access the battery compartment remove the three screws and the

battery door.

2. Remove the battery container, jumpers, and wire harness from the battery

compartment. Place the battery container and batteries onto a flat surface.

Use the provided jumper wires to connect the batteries in series. Connect

the positive terminal (red) of the battery to the negative terminal (black)

of another battery. See photo below for details.

3. Connect the red wire of the harness to the positive terminal (top red) and

the black wire of the harness to the negative terminal (bottom black). See

photo below for details.

ATTENTION: Do not service the 1609-SPD without disconnecting the power

sources due to electric shock hazard for risk of severe injury or death.

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

No comments

Allen-Bradley Bulletin 1609 User Manual Page 7