Allen-Bradley Bulletin 1609 User Manual download pdf (Page 20)

20 Rockwell Automation Publication 1609-UM009C-EN-P - February 2015

Bulletin 1609 UPS

Manual or Remote

Enable/Disable

of UPS Output Selection

The 1609 UPS output is designed to be manually or remotely enabled or

disabled. User is required to enable or disable the remote function switch

on the front panel.

• Selected 'DISABLE' for Manual Enable/Disable the UPS's Output.

• Selected 'ENABLE' for Remote Enable/Disable the UPS's Output.

Manual Enable/Disable/

Self-test

The Power Button on the front of the UPS is used to

manually enable or disable the output of the 1609-D UPS.

To enable the 1609-D UPS, press and hold the power

button until one beep is heard.

To disable the 1609-D UPS, press and hold the power button until three beeps

are heard, then release immediately (takes approximately 3 seconds).

To perform a self-test, press and hold the power button until two beeps are heard,

then release immediately. (The UPS must operate for at least 4 hours before

executing this function)

Remote Enable/Disable

An external switch connected to the Dry I/O terminals 7 and 8 is required

to remotely Enable or Disable the UPS output.

To enable the UPS, close the switch

that is connected to the Dry I/O

terminals 7 and 8.

To Disable the UPS, open the

switch that is connected to the

Dry I/O terminals 7 and 8.

REMOTE FUNCTION

ENABLEDISABLE

87654321

24 Vdc

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 34 35

No comments

Allen-Bradley Bulletin 1609 User Manual Page 20