Allen-Bradley 2755 User Manual download pdf (Page 64)

Downloading Configurations 5–3

This section shows the procedure used to download new firmware to

the AdaptaScan Bar Code Reader. Each Reader is shipped with

factory default firmware. The software will prompt you if you need

to download new firmware.

Verify that your computer is connected to a Reader as shown on

previous page.

To download new firmware to a Reader:

1. Run the AdaptaScan software (Catalog No. 2755-ASN).

2. From the Project menu, choose Open or New.

Highlight

Project

3. Select and open the project. If creating a new project, add a Bar

Code Reader by clicking the New button on the project dialog.

Verify that the DeviceNet address matches the address currently

used by the Reader. If downloading firmware to a new Reader,

check that the DeviceNet address is set to 63 in the Device dialog.

4. From the Project dialog, click the Firmware button. The File

Open dialog appears.

Select .ini

Firmware File

(aaaa is version

number)

Snexaaaa.ini

5. Select the firmware file (shows revision number) to download

and click the OK button.

The following message appears as the firmware is downloaded.

Download will take several minutes. During this time, the

Module LED will flash red.

Resetting. Please Wait . . .

Sending. Please Wait . . .

6. The message disappears when the download is complete.

Downloading Firmware

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 95 96

No comments

Allen-Bradley 2755 User Manual Page 64