Allen-Bradley Bulletin 1609 User Manual download pdf (Page 30)

28 Rockwell Automation Publication 1609-UM007A-EN-P - January 2013

Bulletin 1609 UPS Management Software User Manual

Please refer to the 1609 UPS Management Service operation mode. If the

computer connects to UPS directly (with RS-232 or USB) and can send

commands to its connected UPS then the 1609 UPS Management Service acts as

a "Master". If it connects to UPS directly (with RS-232 or USB) but only listens

to UPS then it is a "USB Slave". If the computer is powered by the UPS, but

obtains the UPS information from Master via TCP/IP network then it is a

"Networking Slave". When 1609 UPS Management Service is a Networking Slave

you must assign the Master IP address so that the Networking Slave can connect

to the Master and obtain the UPS information.

Master: Configures the 1609 UPS Management Service to be a Master.

USB Slave: Configures the 1609 UPS Management Service to be a USB

Slave.

Networking Slave: Configures the 1609 UPS Management Service to be

a Networking Slave.

Master IP Address: When 1609 UPS Management Service is a

Networking Slave you must assign the Master IP address so that the Slave

can connect to the Master host and obtain the UPS information.

Wake On LAN

To wake up the remote host, 1609 UPS Management Software sends notification

through the network. You must provide the IP address and the network hardware

address of the remote host. In Windows98, you can execute the "ipconfig /All"

command under the MS-DOS prompt to obtain the network cards physical

address of the local host. Or, input the "arp -a" command to see the remote host’s

physical address. Your network card must support the remote wakeup feature and

this function should be enabled.

1609 UPS Management Resume The Computer From Suspend Mode:

1609 UPS Management Software will reinstate the computer into normal

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

No comments

Allen-Bradley Bulletin 1609 User Manual Page 30